解紹6噸溫熱水加熱爐停爐有效地新車保養技術
This paper introduces the method of effective maintenance of 6 tons hot water boilers
伴隨
6噸冷水水器常見故障某些停工的的原因工業水器燃燒須得停爐，蒸汽加熱工業水器燃燒留住剛剛須得停下工業水器燃燒的燃燒，漸漸的大大減少工業水器燃燒的高溫直實現工業水器燃燒也沒有有壓力，停爐剛剛要把抽水泵、鼓引排風機和引引排風機關閉系統。
Need to stop because of boiler failure or outage boiler furnace, steam boiler stop should stop before the boiler combustion, slowly until the lower the temperature of the boiler is up to no pressure boiler, boiler stop before to turn off the water pump, fan and induced draft fan.
煤氣電廠鍋爐風機停爐后的保障醫養，劃分成爐離體部和鍋內的防腐施工處理蝕醫養。鍋內的防腐施工處理蝕醫養，重要依據停爐事件的周期的選擇干法醫養和濕法醫養四種。在煤氣電廠鍋爐風機經常注銷時，應特別衡陽雁去爐離體部的防腐施工處理蝕醫養毛病。第一在煤氣電廠鍋爐風機停爐一系列冷卻后，必不可少時應根除肅清熱膨脹面的灰塵和爐排上側、爐體下方的灰渣。隨后要堅定不移廚房廚房煙道有一個定的自然而然空氣流通。常見請況下，為防霉應在爐膛、廚房廚房煙道內加置干枯劑。After the boiler is stopped, the maintenance of the summer is divided into the outside of the furnace and the inside of the pot. The inside of the pot is embalmed, according to the length of the pit stop time and the way of the summer and wet summer. When the boiler is discontinued for a long time, it is important to keep an eye on the embalming problem of the outside of the furnace. First, after the boiler is cooled, it is necessary to completely clean up the ashes of the heating surface and the top of the grate and the ashes of the lower part of the furnace. Then stick to the flue and have certain natural ventilation. In normal condition, to prevent the moisture from the furnace, the flue should be placed in the fire. If lime is used as a dry agent, it should be placed at about 3kg per cubic meter of furnace or flue. When placed, close all ventilation doors tightly. The powdered lime should be changed.
如工業蒸氣煤氣鍋爐燃燒房地址低凹，停爐時期半空泛潮明顯時，則應利用總是中火烘烤和放在乏味劑相分開的方式。我希望工業蒸氣煤氣鍋爐燃燒工業蒸氣煤氣鍋爐燃燒時間相當長，在恢復原狀肅清煙灰后在爐體黑色金屬的表面面涂以紅丹油或沒有防腐施工漆。
If the boiler room is low, and the air tide is severe during the stop furnace, it should be used in the method of baking and placing the dry agent. If boiler time is very long, after thorough purging ash, the surface of the furnace metal surface is coated with red Dan oil or other anticorrosion paint.
而說到爐身體部停爐的抗腐蝕安養方案，則要按停爐日子的長短不一來確定。常見現狀下，停爐不戰勝1個月大左右的適用濕法安養，1個月大左右以上的的應促使干法安養。
As to the preservation of the furnace inside the furnace, it is determined by the length of the stop furnace. In ordinary condition, stop furnace is not exceed a month of usable wet law to be raised, more than a month should adopt dry law to be taken care of.
干法保養時要冒昧以上幾個點相關問題：無趣劑不想直接的碰觸電廠鍋爐合金材料外層，可裝在鐵盤等容器類內;放上無趣劑后，要關嚴手孔和別孔蓋，汽、塑料水管道上的蝶閥必需品剪斷;生氧化鈣變粉應立刻改換。
When you do the work, you should pay attention to the following questions: the dry agent should not be directly exposed to the metal surface of the boiler, but it can be installed in the iron tray and other containers. After the boring agent is placed, the valve must be cut off for the hole and other holes. The powdered lime should be changed in time.
